Lasermad.com

This covers the original Kickstarter 'Relay' 5-tube clock module which as supplied can be used with IN-14 and IN-8-2 nixies. Other similar sized tubes will laso work with varying modifications.
You should have received the following:

• 1x Bag1 - a pink electrostatic safe bag with all of the electronic components.
  1x Bag2 - The paxolin case pieces
  1x Levitating magnet
  1x IN-19 nixie

You may also have received 4x IN-14 or IN-8-2 nixies if the version you bought included them.

The case 'Bag2' contains:

• 1x PCB
  1x Base panel, 0.8mm laminate
  1x Notched loop, 0.8mm laminate
  2x 'narrow shaped' loops, 1.5mm laminate
  1x 'wide shaped' loop, 1.5mm laminate
  2x 'narrow plain' loops, 1.5mm laminate
  3x 'wide plain' loops, 1.5mm laminate
  1x Top panel, 1.5mm laminate

The Relay component Bag1 packing list is:

• R1,2,4,5,7,8,11,12,14,15
  750k 0603 x10
  
  R3,6,9,13,17
  10k 0603 x5
  
  R16
  91R 0603 x1
  
  rx,y
  470r 0603 x2
  
  C1,2,3,4,5
  2u2 16/25V X7R 1206 x5
  
  C6,7,8,9,10,11,12,13,14
  100n 50V X7R 0603/0805 x9
  
  C15,21
  1n 50V 5% C0G 0805 x2
  
  C16 x3
  4n7 50V 5% C0G 1206 x3
  
  C17,18
  100n 200V X7R 1206 x2
  
  D1
  3V9 Zener 500mW MELF x1
  
  D2,6,7,10,11,12,13,14,15,16,17,18,19
  LL148 LL44148 MELF x13
  
  D3,4,5
  BAV99 SOT23 x3
  
  D8,9
  75V 500mW Zener MELF x2
  
  LED1,2,3,4,5,6,7
  WS2812B RGB LED 4 pin x7
  
  T1,2,3,4,5,6,7,8,9,10
  BSS123 SOT23 x10
  
  T11,13,15,17,19
  MMBTA92 SOT23 x5
  
  T12,14,16,18,20
  MMBTA42 SOT23 x5
  
  IC1
  PIC x1
  
  IC2
  CD4028B SOIC16 x1
  
  IR receiver
  CHOD x1
  
  Wire
  0.20mm copper 50 turns x1
  
  Solder
  0.47mm 10 turns x1
  
  Pins
  40x1 strip x1.5 (60 pins)
  
  Nixie sockets x5
  
  Sticky pads x3
  
  M3x20 CS bolt x2
  
  M3 brass nut x2
  
  M3 Brass washer x2

Note some of the component sizes may differ slightly, if so it'll be mentioned during the assembly.